I’m Anders from Sweden. I am looking into restoring my 1976 Renault 30. Last week I serviced the engine and started it for the first time in over 20 years, it worked perfectly!
[avisen] - 1976 Renault 30
Règles du forum
Conditions générales d'utilisation du forum de prv-concept.com
Conditions générales d'utilisation du forum de prv-concept.com
[avisen] - 1976 Renault 30
Bonjour!
I’m Anders from Sweden. I am looking into restoring my 1976 Renault 30. Last week I serviced the engine and started it for the first time in over 20 years, it worked perfectly!
I’m Anders from Sweden. I am looking into restoring my 1976 Renault 30. Last week I serviced the engine and started it for the first time in over 20 years, it worked perfectly!
Re: avisen - 1976 Renault 30
Pictures:
Re: avisen - 1976 Renault 30
Welcome here, after 20 years it's OK for a carb engine but with a K-Jet you better open and clean the whole injection system before the first start or you will have a bad time. Talking about that the probably rusted gas tank can be swaped for a R25 plastic one if I remeber well.
Des boutons de 605, des rétros de 505 et une lunette ar façon R25...
Pas de PRV d'origine mais parait que ça rentre!
Pas de PRV d'origine mais parait que ça rentre!
- heuliez25
- Membre d'or

- Messages : 5217
- Inscription : 30 sept. 2008, 15:49
- Car : Renault 25
- Localisation : Seine et Marne
Re: avisen - 1976 Renault 30
Bienvenue
V6 Turbo 182 ch (Au arrêt)
V6 Turbo 182 ch Limousine (En rodage)

V6 Turbo 182 ch Limousine (En rodage)

- cooldrick
- Membre d'or

- Messages : 7520
- Inscription : 30 sept. 2008, 20:26
- Car : Renault 25
- Localisation : Se ballade dans le temps....
Re: avisen - 1976 Renault 30
Welcome, nice project.
V6turbo 194ch, pas commun mais réelle........
En limousine maintenant.....
Oh Doc' revenir ici c'est comme ci c'était hier....
Mais c'est hier!!! on a du mal a s'y faire hein ?
En limousine maintenant.....
Oh Doc' revenir ici c'est comme ci c'était hier....
Mais c'est hier!!! on a du mal a s'y faire hein ?
Qui est en ligne ?
Utilisateurs parcourant ce forum : Aucun utilisateur inscrit et 1 invité

